Allow for saw kerf when planning repeated cuts
Include the blade’s removed width in a simple stock-length plan.
By CalcForge ·
Method
Add part lengths and the kerf of each separating cut. Also include any waste from squaring an end. Measure the actual kerf if fit is tight.
Worked example
Four 290 mm parts with four 3 mm cuts occupy 1,172 mm of a 1,200 mm blank before end trimming.
What to check
The number of cuts depends on whether a stock end is accepted as a finished edge.
Use the material calculator when the product is sold by area per pack.
Open the material pack calculator ↗
Further reading: WOOD Magazine workshop measuring and marking guide