Rebar Lap Length Calculator - Reinforcing Bar Splice

Estimate the lap length needed to splice two reinforcing bars based on bar diameter, concrete grade, and steel grade.

Enter measurements

Result

Enter measurements to calculate a result.

Formula

Lap length = (design stress × bar dia) ÷ (4 × bond stress factor), adjusted for tension/compression. Take the larger of calculated lap and 300 mm.

Worked examples

16 mm Fe500, M25 concrete, tension

≈ 550 mm required; use 550 mm (larger than 300 mm minimum).

20 mm Fe415, M20 concrete, compression

≈ 644 mm × 0.8 ≈ 515 mm; use 515 mm.

Questions and assumptions

Why take the larger of calculated and 300 mm?

Building codes typically impose a minimum lap length (often 300 mm) regardless of the calculated value.

Does concrete grade affect lap length?

Yes — higher concrete grade gives better bond, reducing required lap length.

Related calculators

Browse measurement and estimating guides